Operator`s manual

Operation RD 27
wc_tx000425gb.fm 30
4.11 Water Spray System
See Graphic: wc_gr002306 and wc_gr002307
Water from the tank is fed to the spray nozzles by an electric pump.
The switch controls the water pump motor. The switch has three
positions:
Position 0 - water spray system OFF
Position 1 - activates intermittent water spray system
Position 2 - activates continuous water spray system
When using the water spray system:
• Check that the tank is full of water.
• Regularly clean the suction filter in the rear half frame.
• Replace damaged filters.
• Only use clean water. Dirty water, even when filtered, will rapidly
clog the tubes of the spraying equipment.
During winter, or when temperatures drop to below 0°C (32°F), drain
off the water tank and spraying equipment. Freezing water may cause
broken hoses, filters and water pumps and may deform the water tank.
Drain the system through the spray bar end plugs (b), the tank drain
plug, the water pump filter bowl, and at the manifold drain (c).
The angle of spray may be adjusted. Insert a screwdriver into the
nozzle (a) and adjust the angle as desired. Ensure water spray covers
entire length of drum.
wc_gr002306
1
2
0