Operator`s manual

Operation RD 27
wc_tx000425gb.fm 24
4.4 Rotating Beacon (if equipped)
See Graphic: wc_gr002304
The rotating beacon illuminates and rotates when the key switch is in
the ON position.
To install the beacon:
4.4.1 Thread the power wire (c) through the light staff and fix it to the upper
connector. Insert the connector into the light staff.
4.4.2 Insert the light staff assembly (a) into the left side of the machine
ROPS and tighten the set screw (b).
4.4.3 Slide the rotating beacon (d) onto the light staff.
4.5 Backup Alarm
See Graphic: wc_gr002237
The backup alarm (e) is located on the rear of the machine.
Start the engine and move the forward-reverse lever to the reverse
position. The backup alarm should sound immediately. The backup
alarm will continue to sound until the forward-reverse lever is moved to
the neutral position or to the forward position.
If the backup alarm does not sound, make the necessary repairs
before using the roller.