Product Manual

wc_tx001968gb.fm
19
PS(A)2 800 / PSW3 1500 Installation
3.9 Cable Assembly
If it is necessary to extend the cable assembly, use a core size equal to or larger
than the original. This is necessary not only to avoid a performance drop, but to
prevent cable overheating which can result in fire, electrical leakage or electrical
shock.
If a cable with cut insulation or other damage is submerged in the water, there is a
danger of damage to the pump, electrical leakage, electrical shock, or fire.
Be careful not to let the cable assembly be cut or become twisted. This may result
in damage to the pump, electrical leakage, electrical shock, or fire.
If it is necessary to submerge the connection wires of the cable assembly in water,
first seal the wires completely in a molded protective sleeve, to prevent electrical
leakage, electrical shock, or fire.
Do not allow the cable assembly wires or power supply plug to become wet.
Make sure the cable does not become excessively bent or twisted, and does not
rub against a structure in a way that might damage it.
If used in a deep-well installation, the cable assembly should be secured every 6 m
(20 ft.).
CAUTION