Product Manual

wc_tx001968gb.fm
14
Installation PS(A)2 800 / PSW3 1500
3.2 Preparing the Machine for First Use
When the pump is delivered, first perform the following checks:
 Inspection
While unpacking, inspect the product for damage during shipment, and make sure
all bolts and nuts are tightened properly.
 Specification check
Check the model number to make sure it is the product that was ordered. Be
certain it is the correct voltage and frequency.
Note: If there is any problem with the product as shipped, contact your nearest
dealer or Wacker Neuson representative at once.
 Product specifications
Do not operate this product under any conditions other than those for which it is
specified. Failure to observe this precaution can lead to electrical shock, current
leakage, fire, water leakage, or other problems.
3.3 Application Area
If the pump is used for outdoor fountains, garden ponds and similar places, or to
drain a swimming pool, the pump must be supplied by an isolating transformer or
connected to a Residual Current Device (RCD) with a residual operating current
not exceeding 30 mA.
The pump must not be used when people are in the water.
Leakage of pump lubricants may cause pollution of water.
Proper plug must be provided according to local codes and standards. Refer to
wiring diagram.
Do not use this pump in liquids other than water, such as oil, salt water, or organic
solvents.
Use with a power supply voltage within ±5% of the rated voltage.
Do not use in water temperatures outside the range of 0–40°C
(32–104°F) which can lead to failure, electrical leakage or shock.
Do not use in the vicinity of explosive or flammable materials.
Use only in fully assembled state.
Note: Consult your local dealer or Wacker Neuson representative before using
with any liquids other than those indicated in this manual.
CAUTION
WARNING