Repair manual

Repair PS2 750

Repair.fm 94

18.Install bearing cover (y) and secure with two screws (x).

Note: Alternately tighten each screw one-quarter turn until bearing

cover compresses spring washer and screws are tight.

19.Secure thermal switch (ab) using two spacers (ac) and two screws

(aa).

20.Position lower half of centrifugal switch (w) over bearing cover (y)

and attach with two screws (r).

21.Position upper half of centrifugal switch (ai) over keyway of rotor

shaft. Lay spring washer (ah) over rotor shaft, compress washer

and secure with pin (ag).

22.Locate single blue wire (bw) coming from stator and reattach to

open terminal on lower half of centrifugal switch (ai).

23.Position cover (ae) and attach with two screws (af). No washers

with these two screws.

24.Correctly position capacitor (k), butting it up against metal tang of

cover assembly. Secure capacitor inside clamp of cover assembly

with one screw (ad).

25.Connect two blue wire connections to capacitor (k) using labelled

wires for correct placement.

26.Position gasket (j) over four protruding studs (flat surface up).

27.Gather red, green and white wires together and guide them through

opening in cover housing (i).

28.Using marks made during disassembly, line up holes in cover

housing (i) and secure with four washers (h) and four acorn nuts

(g).

—Sequentially tighten each acorn nut one-quarter turn until cover

is tightly sealed and torque is distributed evenly.

wc_gr000620