Repair manual

Repair PS2 750

Repair.fm 84

6.4.1.4 Power Supply Reassembly

Note: If, upon inspection and testing, a pump component requires

replacement, use only original manufacturer’s replacement

cables complete with anti-wicking block assembly and

certified for submersible use.

Note: Use only new gaskets and o-rings when reassembling pump.

1. Correctly position capacitor (k), butting it up against metal tang of

cover assembly. Secure capacitor (inside clamp of cover

assembly) with screw (not shown).

2. Reconnect two blue wire connections to capacitor (k) using

labelled wires for correct placement.

3. Position gasket (j) over four protruding studs (flat surface up).

4. Gather red, green and white wires together and guide them through

opening in cover housing (i).

5. Using marks made during disassembly, line up holes in cover

housing (i) and secure with four washers (h) and four acorn nuts

(g).

—Sequentially tighten one-quarter turn until cover is tightly sealed

and torque is distributed evenly.

6. Reposition gasket (f) over bolts and boss of housing cover (i).

wc_gr000454