Repair manual

PS2 750 Repair
Repair.fm 81
9. Prior to removing the housing cover (i) mark where both housing
cover (i) and stator (v) line up with each other. This aids
reassembly.
See graphic wc_gr000619.
10.Remove four acorn nuts (g) and four washers (h) from housing
cover (i).
11.Remove housing cover (i) to gain access to capacitor (k).
12.Label two blue wires (zz) connecting to capacitor (k).Thisaids
reassembly.
13.Loosen single screw (not shown) holding capacitor in place and
remove capacitor for inspection and testing.
6.4.1.2 Power Supply Inspection
1. Measure cable length. The specified cable length is 15m (49ft),
subject to user’s specific application requirements.
—Replace cable if measured length is less than 12m (39ft).
2. Inspect insulation materials of power cable and wires for cuts,
cracking, hardening, abrasive wear or any other condition where
short circuit or water leaks are possible.
3. Inspect power cable and wires for broken connectors.
—Replace cable if continuity tests prove conductors are broken.
4. Inspect sheath for cuts, gouges, cracking, hardening or abrasive
wear.
—Replace power cable if outer sheath is damaged or exposing
interior insulation or protective materials. No tape repair is
permitted.
5. Visually inspect capacitor (k).
—Replace part if there is damage to insulation or any evidence of
electrolyte leaking from capacitor.
zz
wc_gr000452
k