Repair manual

Repair PS2 750

Repair.fm 80

6.4 PS2 750 (1HP)

6.4.1 Power Supply Disassembly, Inspection, Testing and

Reassembly

6.4.1.1 Power Supply Disassembly

Note: Draining oil from oil housing is not required to simply

disassemble, inspect or test power supply. However, if further

disassembly and testing of motor is required, drain oil.

1. Clean top of outer cover housing (d) thoroughly.

2. Prior to working on pump, all electrical power supply circuits must

be disconnected.

3. Coil up excess power cable (p).

4. Remove two acorn nuts (l), two washers (m) and lifting handle (n).

5. Remove two acorn nuts (o) that secure seal (q) in place.

6. Pull power cable (p) up and out of housing cover (i), exposing three

wire connections. Disconnect red, green and white wire connectors

and set power cable (p) aside.

7. Remove outer cover (d) and o-ring (e).

8. Remove gasket (f) if damaged or torn.

wc_gr000619