Repair manual

Repair PS2 400

Repair.fm 58

13.Apply a drop of clean pump oil to white plastic washer (wb) and

insert it inside lip so it is flush. Use a blunt screw driver to press fit

washer in place.

Note: It is important these pieces are assembled correctly before

proceeding.

14.Sub-assemble dust seal and sleeve (u & v) and slide assembled

pieces onto rotor shaft.

See graphic wc_gr000446.

IMPORTANT: DO NOT apply oil to surface where dust seal

contacts sleeve.

15.Align keyway of impeller (w) with rotor (an) and push onto rotor

shaft.

16.Assemble flatwasher (x), lockwasher (y) and stirrer nut (z). While

keeping impeller (w) from rotating, tighten stirrer nut (z).

17.With suction strainer (ac), volute (aa) and three bolts (ab)

assembled, lay gasket (an) on top of volute (aa).

18.Flip sub-assembly to an upright position and align with three

protruding bolts (ab).

19.Secure with three nuts (af).

20.Remove paper towel from upper ball bearing (am) and apply a

liberal amount of lithium (white) grease to upper ball bearing (am)

before laying spring washer (al) on top. Center spring washer (al).

wc_gr000446