Repair manual

PS2 400 Repair

Repair.fm 57

8. Gently insert three hex socket bolts (ak) and apply downward hand

pressure to oil housing (ag) while aligning holes. Assemble finger

tight.

9. Alternately tighten each of bolt one-quarter turn until oil housing

(ag) is secure.

10.Assemble strainer (ac), volute (aa) and volute gasket (ah) in

upright position. Pick up motor and turn to an upright position. Lay

motor over three protruding bolts (ab). Do not attach nuts at this

time.

11.Apply a few drops of clean pump oil to rotor shaft and gently insert

rotor (an) with ball bearings (am & ap) attached inside stator (aq)

and slowly lower shaft through captive mechanical seal (ad).

Note: May require slight pressure. Do not force.

12.Remove sub-assembly from volute (aa). Tuck motor leads inside

motor frame (t) and turn motor and motor bracket upside down.

Make sure wires are not pinched and motor frame (t) sits on a

clean, flat surface.

wc_gr000445