Repair manual

PS2 400 Repair

Repair.fm 55

3. Hold the vacuum position for 10 seconds. The gauge should

remain absolutely stable.

—Replace mechanical seal upon failing vacuum test.

6.2.2.4 Motor Reassembly

Note: If, upon inspection and testing, a pump component requires

replacement, use only original manufacturer’s replacement

cables complete with anti-wicking block assembly and

certified for submersible use.

Note: Use only new gaskets and o-rings when reassembling pump.

1. Insert thin metal piece (cw) into recess of rubber plug (rp).

See graphic wc_gr000606.

2. With stator (aq) inside motor housing, tuck motor leads inside

motor frame (t) and turn upside down. Make sure wires are not

pinched and motor frame (t) sits on a clean, flat surface.

3. Pre-assemble rubber plug (rp). Insert thin metal piece (cw) into

recess. Flip over and push white bushing (wb) into place.

4. Apply a drop of clean pump oil to rubber plug (rp). Using thumb,

press into motor frame (j).

wc_gr000606