Repair manual

Repair PS2 400

Repair.fm 52

13.Pull rotor (an) with upper and lower ball bearings (am & ap) still

attached.

14.Again, tuck motor leads inside motor frame (t) and turn motor and

motor frame upside down. Make sure wires are not pinched and

motor frame (t) sits on a clean, flat surface.

15.Remove three hex socket bolts (ak), oil housing (ag) and o-ring

(ae). Remove rubber plug (xx) from top side of oil housing (ag).

16.Remove three piece portion of mechanical seal (ad).

17.Remove rubber plug (rp) from under side of motor frame (t).

See graphic wc_gr00441.

wc_gr000604

wc_gr000440