Repair manual

PS2 400 Repair

Repair.fm 51

See graphic wc_gr00439.

Note: Make note of orientation to motor bracket

4. If not done already, disconnect two (blue and black) wire

connections to capacitor (o).

5. Remove motor bracket (n) from motor frame (t), allowing motor

wires to pass through oblong opening.

6. Remove spring washer (al).

—Leave upper bushing (am) in place.

7. Remove three nuts (af) so strainer (ac) and volute (aa) remain on

the workbench in an upright position. Tuck motor leads inside

motor frame (t) and turn remainder of pump upside down. Make

sure wires are not pinched and motor frame (t) sits on a clean, flat

surface.

8. While keeping impeller (w) from rotating, remove stirrer nut (z),

lockwasher (y) and washer (x).

9. Remove impeller (w).

—A puller tool, part number 0151079, may be required.

10.Remove dust seal and sleeve as one piece (u & v).

11.Remove white plastic washer (pw).

12.Set pump in upright position on top of volute (aa), aligned with three

mounting bolts (ab).

wc_gr000439

wc_gr000446