Repair manual

Repair PS2 400
Repair.fm 50
5. Feed red, green and white wires, up through opening of housing
cover (l).
6. Align three holes of housing cover and assemble (finger tight) with
three washers (k) and three bolts (j). Alternately tighten each bolt
one-quarter turn until tight.
7. Connect red, green and white wire connection to matching colored
wires of power cable (p).
8. Holding power cable (p) slightly above housing cover (l),push
wires inside protruding boss until cover (s) is flush with boss.
9. Secure cover (s) with two bolts (r).
10.Pre-test pump to verify proper operation.
11.Performance test pump. Test results should be:
6.2.2 Motor Disassembly, Inspection, Testing and
Reassembly
6.2.2.1 Motor Disassembly
Note: Motor disassembly requires disassembly of entire pump.
1. Remove oil.
2. Disassemble power supply. Power Supply Disassembly on
page 44.
3. With pump in upright position, remove rubber gasket (m) from
motor bracket (n).
Maximum head > 12m (39ft)
Maximum volume > 200 ltr/min (53gpm)
Amperage @ 110V <
full load 5.4A
start 12.5A