Repair manual

Repair PS2 400

Repair.fm 44

6.2 PS2 400 (1–2HP)

6.2.1 Power Supply Disassembly, Inspection, Testing and

Reassembly

6.2.1.1 Power Supply Disassembly

Note: Draining oil is not required to simply disassemble, inspect or

test power supply. However, if further disassembly and

testing of motor is required, drain oil.

2. Clean cover housing (l) before disassembly. Pay particular

attention to areas around cover (s) and hose coupling (b).

3. Prior to working on pump, all electrical power supply circuits must

be disconnected.

4. Coil up excess power cable (p).

5. Remove two bolts (f), lifting handle (g) and rubber sleeve (q).

6. Pull power cable (p) upward, exposing three wire connectors.

7. Disconnect red, green and white wire connectors.

8. Make two marks where housing cover (l) and motor frame (t) line

up. This helps alignment and eases reassembly.

See graphic wc_gr000608.

wc_gr000608