Repair manual

General Operation
wc_tx000111gb.fm 34
4. General Operation
4.1 Introduction
The information in General Operation does not in any way replace the model specific
Operator’s Manual and Parts Book that accompany each pump. It is included in this
repair manual as a general overview of operation. Always refer to the specific model
pump Operator’s Manual and Parts Book for:
• Safety Information
• Pump Part Names
• Prior To Use Instructions
• Installation Instructions
• Electrical Wiring
• Parts Ordering Information
4.2 Prior to Operation
When the pump is delivered, first perform the following checks:
• Inspection
While unpacking, inspect the product for damage during shipment, and
make sure all bolts and nuts are tightened properly.
• Specification check
Check the model number to make sure it is the product that was
ordered. Be certain it is the correct voltage and frequency.
NOTE: If there is any problem with the product as shipped, contact
your nearest dealer or Wacker representative at once.
• Product specifications
Do not operate this product under any conditions other than those for
which it is specified. Failure to observe this precaution can lead to
electrical shock, current leakage, fire, water leakage or other
problems.
4.3 Installation
If the pump is used to drain a swimming pool, the pump must be
connected to a Ground Fault Interrupter (GFI).
If the pump is used in fountains, the pump must be connected to a
Ground Fault Interrupter (GFI).
The pump must not be used when people are in the water.
CAUTION
WARNING