Repair manual

PS4 7503HH, PS4 7503HF, PS4 11003HH, PS4 11003HF Repair

Repair.fm 179

6.8.1.4 Power Supply Reassembly

Note: If, upon inspection and testing, a pump component requires

replacement, use only original manufacturer’s replacement

cables complete with anti-wicking block assembly and

certified for submersible use.

Note: Use only new gaskets and o-rings when rebuilding pump.

1. Replace gasket (aa).

2. Replace large diameter o-ring (ar) to outside diameter of cover

housing (ap).

3. Replace o-ring (aq) to inside diameter of cover housing (ap).

4. Turn cover housing on its side, so it rests on the motor frame (ae).

5. Secure thermal switch (as) to inside of cover housing with two

screws (at).

6. Verify that ground wire (al) is securely attached with screw (am).

7. Lay spring washer (ab) on top of upper bearing.

See graphic wc_gr000630.

wc_gr000629