Repair manual

Repair PS2 3703, PS3 3703, PS4 3703, PS3 5503, PS4 5503
Repair.fm 168
24.Add or remove additional gaskets (ao) to obtain recommended
clearance.
25.Secure suction strainer (as) with three stud bolts (ar) and three
washers (aq).
26.Position pump in upright position.
27.Install upper bearing (bw) to rotor shaft.
28.Replace gasket (a).
29.Replace large diameter o-ring (w) to outside diameter of cover
housing (m).
30.Replace o-ring (v) to inside diameter of cover housing (m).
31.Turn cover housing on its side, so it rests on the motor frame (g).
32.Secure thermal switch (p) to inside of cover housing with two
screws (q).
33.Verify that ground wire (n) is securely attached with screw (o).
34.Lay spring washer (d) on top of upper bearing (bw).
See graphic wc_gr000630.
35.Position plate (e) on top of stator. Line up cutouts in plate with
protruding wires.
36.Gather loose wires and guide them through hole while at the same
time lowering cover housing. Align with upper bearing, being
careful not to damage spring washer (d). Do not force.
wc_gr000629
q
p
v
w
m
o
n
wc_gr000630
e
d
a