Repair manual

PS2 1503, PS3 1503, PS2 2203, PS3 2203 Repair

Repair.fm 137

1. With stator (am) inside motor frame (aa), set motor frame upright

on a wooden fixture or equivalent.

Note: Fixture must provide 40cm (4in) clearance for rotor shaft.

2. With upper and lower ball bearings attached, lower rotor (ap) until

lower bearing rests inside casting.

3. Replace gasket (ab).

4. Replace large diameter o-ring (o) to outside diameter of cover

housing (n).

5. Replace o-ring (p) to inside diameter of cover housing (n).

6. Turn cover housing on its side, so it rests on the motor frame (aa).

7. Secure thermal switch (q) to inside of cover housing with two

screws (r).

8. Verify that ground wire (i) is securely attached with screw (j).

9. Lay spring washer (a) on top of upper bearing (ao).

10.Position plate (b) on top of stator (am). Line up cutouts in plate with

protruding wires.

11.Gather loose wires and guide them through hole while at the same

time lowering cover housing. Align with upper bearing, being

careful not to damage spring washer (a). Do not force.

12.Carefully lower housing cover into place.

wc_gr000642

wc_gr000629