Repair manual

Repair PS2 1503, PS3 1503, PS2 2203, PS3 2203
Repair.fm 132
3. With pump on its side, remove three bolts (bb), three washers (ba)
and strainer (az).
4. Remove three bolts (ay), three washers (ax) and suction cover
(aw).
Note: Remove any gaskets (av) between suction cover and volute.
These gaskets are used as shims to adjust impeller
clearance.
5. While holding the impeller (bf) and rotor shaft from rotating, remove
acorn nut (au), lockwasher (at) and thread cover (as).
Note: Impeller vanes may be very sharp due to excessive wear.
Handle with care.
6. Remove impeller (bf).
Note: A puller tool, part number 0151080, may be required.