Repair manual

Repair PS2 1503, PS3 1503, PS2 2203, PS3 2203

Repair.fm 128

3. Submerse the cable in a water tank with conductors on both ends

of cable above the water level. After 24 hours, test the cable

insulation using a Megger tester between conductors and metal

container.

—Replace power cable (x) if readings fall below 30 MΩ.

6.6.1.4 Power Supply Reassembly

Note: If, upon inspection and testing, a pump component requires

replacement, use only original manufacturer’s replacement

cables complete with anti-wicking block assembly and

certified for submersible use.

Note: Use only new gaskets and o-rings when reassembling pump.

1. Replace gasket (ab).

2. Replace large diameter o-ring (o) to outside diameter of cover

housing (n).

3. Replace o-ring (p) to inside diameter of cover housing (n).

4. Turn cover housing on its side, so it rests on the motor frame (aa).

5. Secure thermal switch (q) to inside of cover housing with two

screws (r).

6. Verify that ground wire (i) is securely attached with screw (j).

7. Lay spring washer (a) on top of upper bearing (not shown).

wc_gr000629