Repair manual

Repair PS2 1503, PS3 1503, PS2 2203, PS3 2203
Repair.fm 126
10.Lift housing cover (n) and tip it on its side, allowing it to rest on top
of the motor frame (aa).
11.Loosen two screws (r) and remove thermal switch (q) from
underside of housing cover (n).
See graphic wc_gr000629.
Note: Leave three wire connections to thermal switch (q) attached.
12.Remove large diameter o-ring (o) from outside diameter and o-ring
(p) from the inside diameter of cover housing (n).
13.Remove gasket (ab),plate(b) and spring washer (2).
See graphic wc_gr000630.
6.6.1.2 Power Supply Inspection
1. Measure the cable length. The specified cable length is 9.8m (32ft),
subject to user’s specific application requirements.
—Replace cable if measured length is less than 8m (26ft).
2. Inspect insulation materials of the power supply cable and wires for
cuts, cracking, hardening, abrasive wear or any other condition
where short circuit or water leaks are possible.
3. Inspect the power supply cable and wires for broken connectors.
—Replace power cable if continuity tests prove conductors are
broken.
wc_gr000629
r
q
p
o
n
wc_gr000630
b
a
ab