Repair manual

PS2 1503, PS3 1503, PS2 2203, PS3 2203 Repair

Repair.fm 125

6.6 PS2 1503, PS3 1503, PS2 2203, PS3 2203 (2–5HP)

6.6.1 Power Supply Disassembly, Inspection, Testing and

Reassembly

6.6.1.1 Power Supply Disassembly

Note: Draining oil is not required to disassemble, inspect or replace

the impeller. However, if further disassembly and testing is

required, drain oil.

1. Clean top of cover housing (n) thoroughly.

2. Prior to working on the pump, all electrical power supply circuits

must be disconnected.

3. Coil up excess power cable (x).

4. Remove two bolts (s) that secure power cable (x) in place.

5. Pull power cable (x) upward, exposing three wire connectors.

6. Disconnect red, green and white wire connectors.

7. Separate the motor wires from the power cable wires.

See graphic wc_gr000628.

8. It is not necessary to remove hose coupling (f) or lift handle (c)

unless they are damaged and need to be replaced.

9. Remove four bolts (k) and lockwashers (l) that secure housing

cover (n) to motor frame (aa).

wc_gr000628