Repair manual

Repair PS3 1500, PS3 2200

Repair.fm 120

35.While keeping impeller and rotor shaft from rotating, tighten hex nut

(ao) and acorn nut (ap).

36.Align three holes of retainer plate (ab) with volute (aa).

37.Secure strainer (ac) using four bolts (ae) and four washers (ad).

38.Before turning pump upright, remove oil plug (op) and plug gasket

(pg).

—Pour 270ml (9.1fl-oz) of clean oil into oil housing.

Note: Use SAE 10W/20W oil, Turbine oil VG32 or equivalent.

39.Screw oil plug (op) with plug gasket (pg) into oil housing and

tighten.

40.Set pump upright.

41.If not done previously, seat cone shaped rubber end of power cable

(s) inside cable casing (u). Tighten casing clamp with two screws

(t) when power cable (s) is fully seated inside the cable casing (u).

—PS3 1500, slide new inner and outer shrink tubes (hs) over each

of the three power cable wires before connecting the motor leads

to the power cable leads. Attach identical colored wires and

secure connection with screw (xx) and nut (yy).

See graphic wc_gr000590.

—PS3 2200, attach identical colored wires and secure each

connection with wire nut (m).

See graphic Wire nut connections not shown in wc_gr000590.

wc_gr000591

wc_gr000589

wc_gr000590