Repair manual

PS3 1500, PS3 2200 Repair

Repair.fm 119

23.Position o-ring (w) to lip of motor frame (bc).

24.Place oil housing in upright position.

—Replace seal (ls) if damaged or worn.

25.Secure retaining plate (au) with two screws (at).

Note: Small tab (st) on inside diameter of plate must face

downward.

26.Secure oil lifter (as) to retaining plate with two screws (ar).

27.Slide assembled oil housing over rotor shaft, aligning four mounting

holes and cutout for gasket (av).

28.Secure oil housing (af) with four socket head bolts (ag).

—Sequentially tighten each bolt one-quarter turn until seal is tight

and torque is distributed evenly.

29.Press large diameter wear ring (aj) into recess of oil housing (af).

30.Secure wearing (aj) with plate (ah) and two screws (ai).

31.Sub-assemble dust seal (ak) and sleeve (al) and slide assembled

pieces onto rotor shaft.

IMPORTANT: DO NOT apply oil to the surface where dust seal

contacts the sleeve.

32.Place key (bi) in keyway of rotor shaft.

33.Align keyway of impeller (am) with key in rotor shaft and slide

impeller (am) onto rotor shaft.

34.Secure impeller to rotor shaft with washer (an),nut(ao) and acorn

nut (ap).

wc_gr000627