Repair manual

Repair PS3 1500, PS3 2200

Repair.fm 118

13.Slide capacitor (o) into cover (p) until rear of capacitor contacts “L”

shaped stop.

Note: To tighten screw (n), first gain access by removing two

screws (r) that secure terminal box (j) to cover (p) and pull

terminal box out of the way.

14.Reconnect two (previously labelled) wire connections to

capacitor (o).

15.Install o-ring (w) to base of motor bracket (mb).

16.Verify that gasket (x) and gasket (bs) is in place. Verify that single

ground wire (bt) is securely attached to underside of motor frame

(bc).

17.Feed wires through opening in motor frame (bc) and lower to base

of motor bracket (mb), aligning four mounting holes. Secure with

four washers (c), lockwashers (d) and bolts (e).

—Sequentially tighten each of the four bolts one-quarter turn until

housing cover is tightly sealed and torque is distributed evenly.

18.Turn pump on its side.

19.Press lower seal (zz) into underside of motor frame (bc).

20.Insert gasket (av) into motor frame with deepest end first.

21.Apply oil then slide three pieces of mechanical seal (aq) onto rotor

shaft (bh).

22.Position key (bi) into keyslot of rotor shaft (bh).

wc_gr000588

wc_gr000596