Repair manual

PS3 1500, PS3 2200 Repair

Repair.fm 117

5. Secure lower half of centrifugal switch (bp) with two screws (bo).

6. Secure upper half of centrifugal switch (bn) with washer (bm) and

hex nut (bl).

7. While keeping the rotor shaft from rotating, tighten nut (bl).

8. Position insulated bushing (bs) in clearance hole so wires do not

contact motor bracket.

9. Secure cover (p) to motor bracket (mb) with four screws (z).

Note: Use marks on cover and motor bracket for proper orientation.

10.Slide capacitor (o) into cover (p) until it contacts “L” shaped stop,

then secure with screw (n).

11.Connect any loose wire connections to terminal box (q) using

appropriate diagram for proper wiring.

See graphic wc_gr000609.

12.Replace clear plastic cover (not shown) over front face of terminal

box (q).

Note: Tie up and compress any loose wires so they do not hinder

installation of cover.

wc_gr000594