Repair manual

Repair PS3 1500, PS3 2200
Repair.fm 108
6. Holding the power cable (s) directly above housing cover (j), push
three wires inside the pump, aligning the four mounting holes of the
cable casing. Secure with four bolts (k) and four washers (l).
7. If lift handle (a) is not already attached, put one leg of the lifting
handle through the keyring/warning plate, then align mounting
holes to top of the housing cover (j). Secure with two bolts (b).
Note: If keyring/warning plate is damaged, illegible or missing,
replace with part number RB-726.
8. If hose coupling (h) is not already attached, position gasket (i) and
hose coupling (h) to housing cover and secure with three bolts (f)
and three washers (g).
—Sequentially tighten each of the three nuts one-quarter turn until
seal is tight and torque is distributed evenly.
9. Turn pump on its side and remove oil plug (op) and plug gasket
(pg).
—Pour 270ml (9.1fl-oz) of clean oil into the oil housing.
Note: Use SAE 10W/20W oil, Turbine oil VG32 or equivalent.