Repair manual

PS3 1500, PS3 2200 Repair

Repair.fm 107

5. If not done previously, seat cone shaped rubber end of power cable

(s) inside cable casing. Tighten casing clamp with two screws (t)

when power cable (s) is fully seated inside the cable casing.

—PS3 1500, slide new inner and outer shrink tubes (hs) over each

of the three power cable wires before connecting the motor leads

to the power cable leads. Attach identical colored wires and

secure connection with screw (xx) and nut (yy).

—PS3 2200, attach identical colored wires and secure each

connection with wire nut (m).

—PS3 1500, slide heat shrinks back over each the three exposed

wire connections and apply heat to collapse insulation material

around connection. Make sure any exposed wire or metal is

completely insulated. Allow time to cool before proceeding.

IMPORTANT: DO NOT use electrical tape in place of heat shrink.

—PS3 2200, attach identical colored wires and secure each

connection with wire nut (m).

IMPORTANT: DO NOT use electrical tape in place of heat shrink.

wc_gr000589

wc_gr000590