Repair manual

Repair PS3 1500, PS3 2200

Repair.fm 106

6.5.1.4 Power Supply Reassembly

Note: If, upon inspection and testing, a pump component requires

replacement, use only original manufacturer’s replacement

cables complete with anti-wicking block assembly and

certified for submersible use.

Note: Use only new gaskets and o-rings when reassembling pump.

—PS3 1500, slide capacitor (o) into cover (p) until rear of capacitor

contacts “L” shaped stop. To tighten screw (n), first gain access

by removing two screws (not visible) that secure terminal box (q)

to cover (p) and pull terminal box out of the way.

—PS3 2200, secure capacitor (o) into cover (p).

1. Reconnect two (previously labelled) wire connections to capacitor

(o).

2. Install o-ring (w) to base of motor bracket (j).

3. Verify that gasket (x) is in place and single ground wire (y) is

securely attached to underside of housing cover (j).

4. Feed wires through opening in housing cover (j) and lower to base

of motor bracket, aligning four mounting holes. Secure with four

washers (e), lockwashers (d) and bolts (c).

—Sequentially tighten each of the four bolts one-quarter turn until

housing cover (j) is tightly sealed and torque is distributed

evenly.

wc_gr000585

wc_gr00058