Repair manual

Repair PS3 1500, PS3 2200
Repair.fm 100
6.5 PS3 1500, PS3 2200 (2–3HP)
6.5.1 Power Supply Disassembly, Inspection, Testing and
Reassembly
6.5.1.1 Power Supply Disassembly
Note: Draining oil is not required to simply disassemble, inspect or
test power supply. However, if further disassembly and
testing of the motor is required, drain oil.
2. Clean top of cover housing (j) thoroughly.
3. Prior to working on the pump, all electrical power supply circuits
must be disconnected.
4. Coil up excess power cable (s).
5. Remove four bolts (k) and four lockwashers (l) that secure cable
casing (u) in place.
6. Pull power cable (s) up exposing the red, white and green wire
connections.
—PS3 1500, remove three outer and three inner shrink tubes to
access screw (xx) and nut (yy) connections.
—PS3 2200, remove three wire nuts (m).
—PS3 1500, separate the motor wires from the power cable wire
by removing screws and nuts. Loosely reassemble screws (xx)
and nuts (yy) to power cable wire connections to avoid
misplacing the hardware.
—PS3 2200, separate the motor wires from the power cable wires.