Repair manual

Repair PS2 750
Repair.fm 98
6.4.3.4 Impeller Reassembly
Note: If, upon inspection and testing, a pump component requires
replacement, use only original manufacturer’s replacement
parts.
1. With pump on its side, replace key (be) properly in keyway of rotor
shaft.
2. Align and install impeller (am) over keyway of rotor shaft.
3. Install thread cover (as).
4. Install lockwasher (at) and nut (au).
5. Holding impeller and rotor shaft from rotating, tighten nut (au).
6. Position suction cover gasket (an) to suction cover (ao) and secure
with three stud bolts (aq).
be
wc_gr000583
wc_gr000457
as
am