Product Manual

wc_tx001332gb_FM10.fm
35
PD2A / PD3A Maintenance
Continued from the previous page.
■ Foam element
a.Wash the foam element in a solution of mild detergent and warm water.
b.Rinse the foam element thoroughly in clean water, and allow it to dry
completely.
c. Soak the foam element in clean engine oil until saturated. Squeeze out
excess oil.
6. Re-install the filter elements and air cleaner cover.
Note: In the interests of environmental protection, dispose of waste oil and soiled
rags in accordance with environmental protection legislation.
5.4 Greasing the Connecting Rod Bearing
When Grease the connecting rod bearing every 40 hours of operation or monthly.
Requirements ■ General automotive grease
■ Machine shut down
Procedure Perform the procedure below to grease the connecting rod bearing.
1. Stop the engine.
2. Access the grease fitting of the connecting rod bearing through the access hole
(a).
3. Using a grease gun, pump grease into the fitting until new grease seeps out
between the bearing and the journal.