Product Manual

wc_tx004503en.fm
143
Junction Box Appendix I
Continued from the previous page.
Installing the
work light
cords
1. Use two wrenches to loosen the four connectors (g) on the sides of the junction
box.
2. Insert the light fixture cords through the appropriate four connectors (L1, L2, L3,
L4). Approximately 1 cm (3/8 in.) of each light fixture cord jacket should extend
into the junction box.
3. Tighten the four connectors.
Connecting
the wires
1. Connect the light fixture wires to the coiled cord wires to wires from the four
connectors on the sides of the junction box using Panduit wire crimper CT-100
according to the following chart.
2. Install and connect the four green wires from the light fixtures, the green wire
from the coiled cord, and the green/yellow ground wire (found in hardware
bag 5) into the large connector.
3. Crimp the wires and the wire joint terminal (found in hardware bag 5) together
using the Panduit wire crimper CT-1500.
4. Attach the loose end of the green/yellow ground wire to the ground screw (h) in
the junction box.
5. Use two wrenches to completely tighten the large connector.
6. Replace the cover plate on the junction box.
wc_gr014403
L1
L1
L2
L2
L3
L3
L4
L4
L1
L1
L2
L2
L3
L3
L4
L4
h
Position Light fixture wire Coiled cord wire
L1 Black Red
White Orange
Green —
L2 Black Black
White Brown
Green —
L3 Black Yellow
White White
Green —
L4 Black Blue
White Purple
Green —