Product Manual

wc_si000704en.fm
16
Safety Information LTV
Safe
operating
practices
When operating this machine:
■ Remain aware of the machine’s moving parts. Keep hands, feet, and loose
clothing away from the machine’s moving parts.
■ Do not operate a machine in need of repair.
■ Do not consume the operating fluids used in this machine. Depending on your
machine model, these operating fluids may include water, wetting agents, fuel
(gasoline, diesel, kerosene, propane, or natural gas), oil, coolant, hydraulic oil,
heat transfer fluid (propylene glycol with additives), battery acid, or grease.
Personal
protective
equipment
(PPE)
Wear the following personal protective equipment (PPE) while operating this
machine:
■ Close-fitting work clothes that do not hinder movement
■ Safety glasses with side shields
■ Hearing protection
■ Safety-toed footwear
Before
starting
■ Be sure the machine is on a firm, level surface and will not tip, roll, slide, or fall
while operating.
■ Never connect the machine to other power sources, such as supply mains of
power companies.
■ Never use the machine if the insulation on the electrical cord is cut or worn
through.
■ Never raise the tower or operate the machine in high winds.
■ The tower extends up to 7 m (23 ft). Make sure the area above the trailer is
open and clear of overhead wires and obstructions.
Operation ■ Keep the area under and around the lights clear of people while raising and
lowering the tower.
■ Do not move the machine while it is operating or while the tower is raised.
After use ■ Stop the engine when the machine is not being operated.
■ Close the fuel valve on engines equipped with one when the machine is not
being operated.
■ Ensure that the machine will not tip over, roll, slide, or fall when not being
operated.
■ Store the machine properly when it is not being used. The machine should be
stored in a clean location out of the reach of children.
■ Lower the tower when not in use, or if high winds or electrical storms are
expected in the area.
■ The lamps become extremely hot during use! Allow the lamp and fixture to cool
10–15 minutes before handling.