Product Manual

wc_tx004503en.fm

133

Tongue assembly Appendix I

Continued from the previous page.

Installing the

swivel jack

Perform the procedure below to install the swivel jack.

1. Locate the swivel jack (e).

2. If necessary, remove the locking pin (f) from the holes in the tongue jack.

3. Fit the socket (g)

of the swivel jack

over the circular boss on the tongue

assembly.

4. Rotate the tongue jack so the foot (h) rests on the ground.

5. Align the top hole in the swivel jack socket with the top hole on the circular boss.

6. Insert the locking pin through the aligned holes (top and bottom) to secure the

swivel jack in place.

Routing the

tongue

harness

Perform the procedure below to route the tongue harness.

1. Route the tongue harness (j) along the side of the tongue as shown in the

illustration.

2. Tighten screws on the P-clamps (k) until the P-clamps are completely closed.

wc_gr014387

wc_gr014473