Product Manual

wc_tx004503en.fm
132
Appendix I Tongue assembly
16.6 Installing the Tongue Assembly
Materials
needed
 Tongue assembly
 Swivel jack
 Hardware bag 4
Installing the
tongue
assembly
Perform the procedure below to install the tongue assembly.
1. Fasten the tongue assembly (a) to the light tower using the following hardware
from bag 4 as shown in the illustration:
 Three M12 x 30 screws (b) on each side of the tongue assembly
 Three B13 flat washers (c) on each side of the tongue assembly
 Three M12 serrated flange nuts (d) on each side of the tongue assembly
2. Tighten the screws to a torque of 106 Nm (78 ft. lb.).
This procedure continues on the next page.
wc_gr014386
c
b
a
c
b
d