Product Manual

wc_tx004503en.fm

131

Outriggers Appendix I

16.5 Installing the Outriggers and Swivel Jacks

Materials

needed

 Two outrigger

 Two swivel jacks

Installing the

outriggers

Perform the procedure below to install the outriggers.

1. Locate the locking pin (a) at the outrigger socket (b).

2. Position the outrigger (c) so the holes (d) face the same direction as the locking

pin.

3. Pull the locking pin and insert the square end of the outrigger into the outrigger socket.

4. Align the hole in the outrigger with the locking pin. When the hole is aligned,

release the locking pin to fasten the outrigger in place.

5. Repeat steps 1–4 to install the second outrigger on the other side.

Installing the

swivel jacks

on the

outriggers

Perform the procedure below to attach a swivel jack to an outrigger.

1. Locate a 10-inch swivel jack (e).

2. If necessary, remove the locking pin (f) from the swivel jack.

3. Fit the socket

(g)

of the swivel jack over the circular end of the outrigger.

4. Rotate the swivel jack so the foot (h) rests on the ground.

5. Align the top hole in the swivel jack socket with the top hole in the outrigger.

6. Insert the locking pin through the aligned holes (top and bottom) to secure the

swivel jack in place.

7. Repeat steps 1–6 to install the second swivel jack on the other side.

wc_gr014377