User manual

wc_si000773gb.fm
22
Labels HIF 690
y
y STARTING INSTRUCTIONS
1.Reach inside the heat chamber and on the left rear side of the engine turn the
Master Switch clockwise 45 degrees to ON.
2.Depress the fuel pump primer until all air is purged.
3.On the control panel flip the toggle switch to ON position.
4.Hold the Murphy button down.
5.Verify that the "wait to start" red light is OFF before proceeding.
6.Depress the starter button until the engine engages.
7.NEVER hold in the starter button for more than 10 seconds at any one time.
8.Continue to hold the Murphy button until the engine is running and the oil
pressure gauge reads 5 psi or more.
9.If the engine fails to start, repeat cycle.
10.Maintain 1500 RPM for several minutes allowing engine to warm up properly.
CONSULT OPERATOR'S MANUAL FOR ADDITIONAL INFORMATION
COLD STARTING
1.In below freezing weather, plug the engine block heater that is mounted on the
unit into a 120V electrical outlet for approximately 2.5 hours.
2.In sub-arctic weather below -20°F, preheat the unit in a shop or other structure
before operating. Also plug in the engine block heater.
SHUT DOWN
1.Lower the RPM to approximately 1200-1500 for several minutes to allow
engine to cool down.
2.Flip the toggle Switch or Key as equipped on the control panel to the OFF
position.
Ref. Label Meaning