Operator`s manual

GPS 9700 Operation
wc_tx000954gb.fm 31
3.13 Engine Auto Idle
The auto idle switch (a) automatically reduces engine speed 5
seconds after all appliances or tools attached to the generator have
been turned off. Engine automatically returns to full speed when a tool
or appliance is turned back on.
To turn auto idle feature on, push auto idle switch to ON (I). This
position is recommended while the generator is running to minimize
fuel consumption. To avoid extended engine warm-up periods, keep
switch OFF (O) when starting the engine and until engine reaches
operating temperature.
3.14 Engine Speed
Generators require a fixed engine speed to maintain the correct
voltage. Engine speed is controlled by a governor which automatically
adjusts to varying loads on the engine to maintain a constant speed of
3600 rpm. There is no throttle control. Use the Auto Idle switch on the
generator to control engine speed.
Note: The battery must have the appropriate charge (nine volts
minimum) for the generator governor to perform properly. If the
generator starts but will not run at speed, check battery charge.