Operator`s manual

GPS 9700 Labels
wc_si000672gb.fm 19
L
Improper connection of generator to a
building’s electrical system can allow electrical
current from the generator to backfeed into
utility lines. This may result in electrocution of
utility workers, fire, or explosion. Connections
to a building’s electrical system must be made
by a qualified electrician and comply with all
applicable laws and electrical codes.
Do not run the engine near open flames.
M Emission Control Information
This equipment meets U.S. EPA EVAP
standards.
Evaporative Family: CWIXNHEQCL2
Exempt from tank permeation standards
under 40 CFR 1054.145.
O
A nameplate listing the model number, item
number, revision number, and serial number
is attached to each unit. Please record the
information found on this nameplate so it will
be available should the nameplate become
lost or damaged. When ordering parts or
requesting service information, you will always
be asked to specify the model number, item
number, revision number, and serial number
of the unit.
P
GFCI TEST INSTRUCTIONS - TEST BEFORE EACH USE
Normal operating state - sensing device green LED is "ON" and circuit breaker is at "ON"
position.
Step 1: Press "TEST" button. Green LED should go "OUT" and red LED should come "ON" and
circuit breaker should trigger to "OFF" position.
Step 2: If sensing device LED or breaker does not trip or change state, "DO NOT USE". Consult
an electrician for assistance.
Step 3: Press "RESET" button. Red LED should turn "OFF" and green LED should turn "ON".
Step 4: Manually reset (switch) circuit breaker to "ON" position to restore circuit power.
CWIXNHEQCL2
5200003299