Repair manual

Operation GP Repair

wc_tx000586gb.fm 20

2 Operation

2.1 Information Regarding Operation

The information regarding the operation of the machine included in this

manual is condensed. Refer to the Operator’s Manual for complete

operating instructions. Always read, understand, and follow the

procedures in the Operator’s Manual when operating the machine.

2.2 Determining Power Requirements

This generator is designed to operate single-phase, 60 Hz appliances

running at 120 VAC or 240 VAC. Check the nameplate or label

provided on tools and appliances to make sure their power

requirements match the power output of the generator.

Some appliances and tools require a surge of current when starting.

This means that the amount of power needed to initially start the

equipment is larger than the power required to keep it running. The

generator must be capable of supplying this “surge” current. Other

types of appliances require more power than is actually stated on their

nameplate.

The information in “Approximate Starting Power Requirements” is

offered only as a general guideline to help you in determining power

requirements for different types of equipment. Check with your nearest

Wacker Neuson dealer, or contact the manufacturer or dealer of the

tool or appliance, with questions regarding its power requirements.

NOTICE: If a tool or appliance does not reach full speed within a few

seconds when switched on, turn it off immediately to avoid damage.

Approximate Starting Power Requirements:

Approximate Starting Power Requirements

• Incandescent lights and appliances such as irons and hot plates,

which use a resistive-type heating element, require the same wattage

to start and run as is stated on their nameplates.

• Fluorescent and mercury lamps require 1.2–2 times their stated watt-

age to start.

• Electrical motors and many types of electrical tools often require a

large starting current. The amount of starting current depends on the

type of motor and its use.

• Most electrical tools require 1.2–3 times their stated wattage for start-

ing.