Operator`s manual

Maintenance G 25
78 wc_tx001046gb.fm
7.6 Checking Engine Coolant
7.6.1 Stop the engine.
7.6.2 Open the radiator filler cap slowly in order to relieve the pressure.
Remove the filler cap after the pressure has been released.
7.6.3 Verify that the coolant level of the radiator is 19 mm (3/4 in.) below the
bottom of the filler neck. Add more coolant if necessary to maintain
this level.
7.6.4 Inspect the radiator filler cap and filler cap seal for damage. Clean the
radiator filler cap or replace it if necessary.
7.6.5 Re-install the radiator filler cap.
7.7 Maintaining the Trailer
Tires - Keep tires inflated to the proper pressure as shown on the tire
sidewall, and check tread periodically for wear. Replace tires as
required.
Wheels - Check that lug nuts holding wheels are tight. Replace any
missing nuts immediately.
Axle Hubs - Grease axle hubs through grease fittings using a good
wheel bearing grease.
Brakes - Check operation of brakes before each trip.
Check level of brake fluid in actuator at front of trailer at regular
intervals. Fill to approximately 25mm (1 in.) below top of reservoir
using DOT-3 heavy-duty brake fluid. Tighten filler plug securely.
Note: If fluid level has fallen too low, bleed brake lines to remove any
air trapped in lines.
WARNING
Burn hazard. Engine coolant is hot and under pressure at operating temperature. It
can cause severe personal injury.
f Check the coolant level only after the engine has been shut down and is cool.
WARNING
Burn hazard. Coolant can contain alkali.
f Avoid coolant contact with skin and eyes.