Operator`s manual

Safety Information G 25
14 wc_si000295gb.fm
This will notify everyone that the unit is being serviced and will reduce
the chance of someone inadvertently trying to start the unit. If the unit
is connected to a remote start or transfer switch, make sure the
remote switch is also off and tagged.
1.4.2 Ground Connection
The generator must be connected to a good earthen ground for
proper operating safety!
A central “equipment ground” is provided at the customer connection
lugs. This point is connected directly to the generator set base. All
other system grounds are connected to this central point. Ground the
generator in accordance with the standards defined in national, state,
and local regulations.
1.4.3 Do not attempt to open the radiator cap while the unit is running or
before the engine has cooled down. Severe burns may result!
1.4.4 Do not allow water to accumulate around the base of the machine. If
water is present, move the machine and allow the machine to dry
before servicing.
1.4.5 Do not service the machine if your clothing or skin is wet.
1.4.6 Do not allow untrained personnel to service this equipment. Only
trained electrical technicians should be allowed to service the
electrical components of this equipment.
1.4.7 Do not modify the machine without the express written approval of the
manufacturer.
1.4.8 Do not pressure wash the control panel, generator end, or any other
electrical components when cleaning the unit. Never allow water to
accumulate around the base of the generator set. If water is present,
DO NOT service!
1.4.9 Allow the engine to cool before performing any service work on the
machine.
1.4.10 Remain aware of moving parts and keep hands, feet, and loose
clothing away from the moving parts of the generator and engine.
1.4.11 Replace all guards, fasten doors, and make sure all safety devices
operate properly after making repairs or servicing the equipment.
1.4.12 Keep the machine clean and labels legible. Replace all missing and
hard-to-read labels. Labels provide important operating instructions
and warn of dangers and hazards.
1.4.13 Check all external fasteners at regular intervals.
1.4.14 Make sure slings, chains, hooks, ramps, jacks, and other types of
lifting devices are attached securely and have enough weight-bearing
capacity to lift or hold the machine safely. Always remain aware of the
location of other people in the area when lifting the machine.