Operator`s manual

wc_tx003553gb_FM10.fm

Rammer

Maintenance

5.12 Adjusting the Idle Speed

Requirements

■ Tachometer

■ Phillips screwdriver

Procedure

Perform the procedure below to adjust the idle speed.

1. Remove the guard (c).

2. Start the engine and allow it to warm up to operating temperature.

3. Using the tachometer, set the engine idle speed with engine running at idle and

choke (a) fully open.

4. Adjust idle speed screw (b) in or out to obtain correct idle speed. Refer to

Technical Data for correct idle and operating rpm.

NOTICE: Do not over-tighten the idle speed screw. Damage to the carburetor may

occur.

5. Re-install the guard.

Result

The idle speed has now been adjusted.