Operator`s manual

wc_tx003553gb_FM10.fm
65
Rammer
Maintenance
5.11 Replacing the In-Line Fuel Filter Assembly
When Every 5 months or every 500 hours (whichever comes first)
Requirements ■ Engine stopped
■ Replacement in-line fuel filter assembly
Procedure Perform the procedure below to replace the in-line fuel filter assembly. The in-line
fuel filter assembly consists of the fuel filter (a) and two hoses (b).
1. Set the throttle to the OFF position. This will close the fuel valve.
2. Remove the existing in-line fuel filter assembly and discard it in accordance with
local environmental protection regulations.
3. Connect the new in-line fuel filter assembly, making sure to orient the fuel filter
as shown in the illustration.
4. Set the throttle to the IDLE position. This will open the fuel valve.
5. Check for fuel leaks before restarting the machine.
Result The in-line fuel filter assembly has now been replaced.
wc_gr010413
a
b
b
b
a
a
BS 50-2i, BS 60-2i, BS 70-2i BS 50-2, BS 60-2, BS 70-2