Operator`s manual

wc_tx003552gb_FM10.fm

Rammer

Operation

Continued from the previous page.

Purging the

oil discharge

line

Perform the procedure below to purge the oil discharge line.

1. Locate the oil discharge line (c).

2. If air bubbles are visible in the oil discharge line, they must be manually purged

using one of two possible methods:

Method 1: Disconnect the oil discharge line at the oil pump (d). Using a plastic

syringe (f) filled with oil, inject oil into the oil discharge line until the air bubbles

are gone and oil is visible up to the “Y” connector (e).

Method 2: Disconnect the oil discharge line at the oil pump (d) and at the “Y”

connector (e). Connect a vacuum pump (g) to the "Y" end of the oil discharge

line. Place the oil pump end of the oil discharge line in a container of fresh oil.

Suction oil through the oil discharge line until the air bubbles are gone.

3. After the air bubbles have been purged, reconnect the oil discharge line. Make

sure that the connections are tight with no oil leaks.

4. Wipe residual oil from the oil discharge line and fittings.

Result

The oil lines have been purged.

wc_gr010578