Operator`s manual

PUREHEAT™ HYDRONIC AIR HEATER OPERATOR’S MANUAL–SECTION 2

2.1.4 Insulate Circulation Hoses

Any Circulation Hoses exposed to the outdoor elements should be insulated for maximum heat delivery

into work space. Ground Heaters, Inc. recommends wrapping a cut-to-size Red Wave™ Blanket around

exposed Circulation Hoses. Secure the wrapped blankets to minimize air infiltration and heat loss.

Contact your local Ground Heaters Distributor for additional system configuration advice.

2.1.5 Circulation Hose Protection

Do not drive any vehicles or equipment over the Circulation Hoses. If the Hoses must be deployed in

high traffic areas, construct ramps or guards to protect from damage.

HTF may discolor floor surface. Provide extra protection and care to circulation

hoses when floor appearance is critical. Place hoses away from high traffic areas

whenever possible.

2.2 PRE-START UP CHECKS

2.2.1 Positioning

1. Position the Pureheat’s 5-Port On-Board Manifold as close as possible to the space to be heated.

Circulation Hoses can then easily enter and exit the structure.

The Pureheat must be positioned a minimum of 12 ft (3.6 m) from fuel source or

combustible materials.

2. Chock the wheels to prevent accidental rolling.

3. Use the Heavy Duty Jack-Stand to position the machine as level as possible.

2.2.2 Unloading HX200 Heat Xchangers

1. OPEN the Rear Doors and remove the

aluminum Ramp from its storage location

above Xchangers

2. Position the Ramp onto the Ramp

Alignment Pins to unload either the left side

or the right side HX200s. (Photo 2-1)

NOTE: Each HX200 Heat Xchanger

is equipped

with wheels and fold-out handles.

3. Position the HX200s inside the building per

your heating plan. (Refer to Appendix C-1,

Pureheat APPLICATION LAYOUTS.)

NOTE: Each HX200 Heat Xchanger

must be

connected to a separate

15 amp. 120 volts

AC 60 Hz electrical circuit. Use 12-3

extension cords of no more than 100 ft (30

m) in length.

4. Momentarily turn the BLOWER Switch ON to test Blower operation then turn the BLOWER Switch

OFF.

2-1