Repair manual

Troubleshooting the Burner Cub 200/300
42 ghi_tx001207gb.fm
6.2 Checking the Cad Cell
Requirements  Power disconnected from the machine
 Multimeter
Procedure Perform the procedure below to check the cad cell.
1. Disconnect the power cord from the power supply.
2. Open the access panel (a).
3. Twist and pull the cad cell (b) from the flame head.
4. Remove the screws (c) that hold the control panel and pull the control panel
from the machine.
5. Remove the cover (d) from the control panel.
This procedure continues on the next page.