Repair manual

Cub 200/300 Troubleshooting the Blower
ghi_tx001207gb.fm 29
5.1 Checking the Fuse
Requirements 120V power source
Procedure Perform the procedure below to check the fuse.
1. Connect the power cord to a 120 VAC power supply.
2. Observe the green light (x).
Does the green light illuminate?
3. Disconnect the power cord from the electric power supply.
4. Remove the screws that hold the control panel and pull the control panel from
the machine.
This procedure continues on the next page.
Yes ____ No ____
The fuse is OK. Continue.
WARNING
Electric shock hazard. High voltage exists inside the control panel when the power
cord is plugged into a power supply. Electric shock can cause serious injury or
death.
f Disconnect the machine from the electric power supply before continuing this
procedure.